Two measurements are enough to choose a safety glove size. Use a soft tape measure and keep the hand relaxed and flat. For circumference, measure around the hand at the base of the thumb and just below the little finger. For length, measure from the tip of the middle finger to the wrist crease. Write both numbers down in millimeters, because the size chart uses millimeters.
Measure the hand you work with most, and measure again if the other hand looks different. Repeat each measurement once to confirm it. A tape that is pulled tight or left loose will move the result by a size.
The size chart follows EN ISO 21420, the general requirements standard for protective gloves. Each row is one size. The first column is the EU size, from 4 to 13. The second column is the US size, from 3XS to 4XL. The last two columns give the circumference and the hand length in millimeters that the size is built around.
Find your circumference in the third column and read across to the size. Then check your length against the fourth column. For example, size 8 (US M) lists a circumference of 203 mm and a hand length of 182 mm. The smallest sizes list a length of under 160 mm and the largest list a length of over 215 mm.
The size chart does not say what to do when your measurements fall between two rows, so this page does not set a rule for it. Open the product page for the glove you want, check which sizes are recorded for that model, and contact us if you would like advice before you order.
Not every model comes in every size. The size list on each product page is the sizes recorded for that glove. Once the fit is settled, the next decision is the protection rating. Read EN 388 vs ANSI cut levels for both scales in full, use the glove finder to narrow the choice, or read the sizing, care and replacement guide. The full range is in the catalog.
Measure around the hand at the base of the thumb and just below the little finger for circumference. Measure from the tip of the middle finger to the wrist crease for length. Then find both figures in the size chart.
The size chart follows EN ISO 21420, the general requirements standard for protective gloves. It lists EU sizes 4 to 13 and US sizes 3XS to 4XL, with circumference and hand length in millimeters.
The size chart does not give a rule for in-between measurements. Check the size list on the product page, and contact us if you want a second opinion before you order.
No. The sizes recorded vary by model, so check the size list shown on each product page before you order or request a quote.